Technical Drawing

Give me a practice set on completing the four standard equal-area constructions on one she

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

Be my SS1 Technical Drawing teacher for this one point: 1. Describe the concept of enlarge

Set me five practice tasks on enlarge and reduce plane figures based on the ratio of areas

Set me five practice tasks on demonstrating and carry out the construction of plane figure

Show me a worked example on success: a correctly named and exported file produced that mat

I am revising Isometric Drawing II for SS1 Technical Drawing. Test me on 2. Construct isom

I am revising Quadrilaterals for SS1 Technical Drawing. Test me on 4. Construct any quadri

Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr

Show me a worked example on success: four-centre ellipses drawn correctly in all three pla

I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a

Show me a worked example on given two sides and the included angle with an error somewhere

I am revising Angles and Triangles II for SS1 Technical Drawing. Test me on 4. Construct a

Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the

Show me a worked example on constructing special quadrilaterals and one from four sides an

Let me talk you through 1. State the purpose of drawing standards from the Drawing Standar

Write a short SS1 Technical Drawing answer about 2. Identify standard line types and their

Show me a worked example on 4. Calculate the interior and exterior angles of any regular p