Technical Drawing

Set me a small project on twelve-position method on the board, stressing that each crank p

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Give me a wrong or muddled explanation of drawing a four-bar linkage to given link lengths

Quiz me on drawing a slider-crank mechanism and plot the locus of the mid-point of the con

Set me a small project on generating circle into twelve equal parts, the kind I could fini

Be my SS2 Technical Drawing teacher for this one point: plotting the locus of a stated poi

Take checking each other's stroke measurement against the calculated value of twice the cr

Set me five practice tasks on calculating the stroke of a slider-crank whose crank radius

Show me a worked example on what happens to the output at a dead-centre position with an e

Set me five practice tasks on fully dimension a given third angle drawing, using at least

Show me how are given a plan and elevation only and must state the position of each point

Give me a practice set on rod at an angle to both card planes and rotates it into a positi

You are my personal SS2 Technical Drawing tutor. Teach me the term locus, as it is taught

Set me five practice tasks on sketching the locus of a point on the rim of a wheel rolling

Let me talk you through the meaning of link, joint, crank, lever, slider and frame from th

Show me a worked example on here the locus plot supplies the evidence with an error somewh

Write a short SS2 Technical Drawing answer about three applications of special curves in e

I am an SS2 student studying Loci and Special Curves in Technical Drawing. Explain examine

Show me a worked example on in two sentences why a parabolic dish concentrates a signal at

Be my SS2 Technical Drawing teacher for this one point: drawing the tangent and normal at