Technical Drawing

Set me five practice tasks on success: five dimensions set off from the diagonal scale cor

Set me five practice tasks on demonstrating and carry out the construction of plane figure

Set me five practice tasks on success: both folded models close with a gap of less than 2

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Give me a practical task on layout of a title block on the board with proportions marked.

Set me five practice tasks on two advantages of CADD, at the level expected in SS1 Drawing

Set me five practice tasks on demonstrating safe handling of board, T-square and compass,

Give me a practice set on each construction step by step on the board. Students construct

Set me five practice tasks on constructing the special angles without a protractor, at the

Set me five practice tasks on constructing triangles from all three sets of given data, at

Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Set me five practice tasks on the types of quadrilaterals with their properties, at the le

Write a short SS1 Technical Drawing answer about 2. Identify standard line types and their

Give me a wrong or muddled explanation of formal assessment of the first term programme of

Set me five practice tasks on accuracy of construction assessed separately from knowledge,

Give me a practice set on each of the three methods for a regular heptagon. Students const

Set me five practice tasks on enlarge and reduce plane figures based on the ratio of areas