Technical Drawing

I am revising Loci and Special Curves for SS2 Technical Drawing. Test me on the parabola,

Set me a quick recall test on constructing a parabola by the focus and directrix method fo

Quiz me on constructing the involute of a circle of 40 mm diameter for one complete revolu

Quiz me on applying the correct line types for outline, hidden detail, centre lines and co

Set me a quick recall test on set out a segmental arch geometrically and mark voussoir joi

Give me a practice set on listing five machines seen locally that use linkages for SS2 Tec

Show me a worked example on drawing the second auxiliary elevation of a shaped block and l

Give me a practice set on comparing the two curves and account for any difference for SS2

Quiz me on drawing a slider-crank mechanism and plot the locus of the mid-point of the con

Set me a small project on twelve-position method on the board, stressing that each crank p

I am revising True Shapes I for SS2 Technical Drawing. Test me on determine the true shape

Set me five practice tasks on the four conic sections and the cutting plane that produces

Quiz me on develop the lateral surface of a truncated cylinder, from the SS2 Technical Dra

Give me a practice set on cutting paper cylinder to show that the seam edge of the develop

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Quiz me on develop the surfaces of the intersecting prisms and pyramids, showing the openi

You are my personal SS2 Technical Drawing tutor. Teach me and locate the ground line, hori

Write a short SS2 Technical Drawing answer about set out two vanishing points on the horiz

I am revising Orthographic Projection II for SS2 Technical Drawing. Test me on assessed AO

Quiz me on producing an oblique (cabinet) drawing of the same block with the depth drawn a