Technical Drawing

Quiz me on 2. Define isometric drawing and the isometric axes at 30° to the horizontal, fr

Set me a quick recall test on 2. Prepare a title block and border to standard proportions

I am revising Angles and Triangles II for SS1 Technical Drawing. Test me on 4. Construct a

Set me a quick recall test on 4. Construct eccentric and concentric circles to given dimen

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me

Quiz me on 4. Explain the geometric basis of each construction using bisectors, from the S

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

Quiz me on 3. Construct a square equal in area to a given rectangle, from the SS1 Technica

Quiz me on 3. Plot the locus of a point on a simple crank-and-connecting-rod mechanism, fr

Quiz me on 2. Prepare the development of truncated prisms and cylinders, from the SS1 Tech

Write a short SS1 Technical Drawing answer about 4. Use drawing materials and instruments

Show me a worked example on producing vertical and inclined lettering to consistent height

Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number

Set me a quick recall test on 2. Identify the types of angles: acute, right, obtuse, refle

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Be my SS1 Technical Drawing teacher for this one point: 3. Describe an escribed circle and

Set me a quick recall test on 4. Apply standard conventions for scale statement at SS1 lev

Set me five practice tasks on success: both projection symbols drawn to correct proportion