Technical Drawing

I am going to explain 3. Describe the purpose of lettering to you, as an SS1 Technical Dra

I am going to explain 3. Determine true lengths of the edges of full and truncated solids

Let me talk you through 3. State the advantages of CADD over manual drawing from the Drawi

Let me talk you through 1. State the purpose of drawing standards from the Drawing Standar

Act as my study partner. I will teach you 3. State the properties of regular polygons incl

Act as my study partner. I will teach you 3. Describe the applications of enlargement and

Let me talk you through 3. Apply the radial (ray) method of enlargement from a chosen pole

Let me talk you through 3. Produce the front elevation, end elevation and plan of a given

Quiz me on 4. Explain the geometric basis of each construction using bisectors, from the S

I am going to explain consolidation of drawing practice, line work to you, as an SS1 Techn

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

I am going to explain 3. Explain why triangles on the same base and between the same paral

Act as my study partner. I will teach you 4. Convert a given irregular polygon into a tria

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Act as my study partner. I will teach you 3. Develop the pattern for a transition piece be

Act as my study partner. I will teach you 4. Construct an oblique drawing using the centre

Write a short SS1 Technical Drawing answer about 4. Verify the accuracy of an enlargement