Technical Drawing

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Let me talk you through 1. State the purpose of drawing standards from the Drawing Standar

Act as my study partner. I will teach you 3. State the properties of regular polygons incl

Act as my study partner. I will teach you 3. Describe the applications of enlargement and

I am going to explain 3. Explain why triangles on the same base and between the same paral

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

I am going to explain 3. Determine true lengths of the edges of full and truncated solids

Let me talk you through 3. Produce the front elevation, end elevation and plan of a given

I am going to explain 3. Describe the purpose of lettering to you, as an SS1 Technical Dra

Let me talk you through 3. State the advantages of CADD over manual drawing from the Drawi

Be my SS1 Technical Drawing teacher for this one point: 1. Demonstrate safe handling of th

Let me talk you through 3. Draw parallel and perpendicular lines using T-square and set sq

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

Let me talk you through 3. Apply the radial (ray) method of enlargement from a chosen pole

Act as my study partner. I will teach you 4. Convert a given irregular polygon into a tria

Let me talk you through 4. Construct common tangents to two equal and to two unequal circl

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Act as my study partner. I will teach you 3. Develop the pattern for a transition piece be

I am going to explain 3. Place dimensions on vertical, horizontal and angular features to