Technical Drawing

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

I am going to explain rendering the finished view with tone and texture to distinguish two

I am going to explain sketching freehand front, top and side views of two of the same tool

I am an SS2 student studying Orthographic Projection III in Technical Drawing. Explain add

Act as my study partner. I will teach you drawing the auxiliary views of a full cone and a

Act as my study partner. I will teach you drawing the sectional elevation and plan of a do

Show me a worked example on why the cut face appears as a straight line in one view and an

Set me five practice tasks on labelling the cutting plane, viewing arrows, at the level ex

Let me talk you through the effect on the finished view of moving the station point from t

Give me a practical task on card box round a small block to show the three planes opening

Give me a practice set on arranging three cut-out views on the desk in first angle order f

Write a short SS2 Technical Drawing answer about constructing an isometric view from given

Show me a worked example on drawing the auxiliary views of a full hexagonal prism and a sq

You are my personal SS2 Technical Drawing tutor. Teach me how a second auxiliary view is u

Set me five practice tasks on the sequence of steps needed to obtain a second auxiliary vi

I am an SS2 student studying Auxiliary Views III in Technical Drawing. Explain obtain the

Give me a practice set on rotating the UCS and setting up a viewport so the auxiliary dire

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Show me how are given a plan and elevation only and must state the position of each point

Show me a worked example on why a line parallel to a plane appears in true length in the v