Technical Drawing

Set me five practice tasks on drawing three views of a given block in first angle projecti

Set me five practice tasks on fully dimension a given third angle drawing, using at least

Give me a practice set on modelling-clay cone at four angles in front of the class for SS2

Give me a practice set on arranging three cut-out views on the desk in first angle order f

Act as my study partner. I will teach you drawing three views of a given component in thir

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

Give me a practice set on two planes from two sheets of card at right angles for SS2 Techn

Give me a practice set on rod at an angle to both card planes and rotates it into a positi

Give me a practice set on card triangle in the two-plane model and turns it until the clas

I am going to explain constructing a parabola inside a given rectangle 100 mm by 60 mm by

Give me a wrong or muddled explanation of drawing a four-bar linkage to given link lengths

Be my SS2 Technical Drawing teacher for this one point: drawing the front elevation, plan

Show me how drawing three first angle views of a shaped block from a given pictorial view

Show me how converting a given first angle drawing into an isometric view works in real li

Set me five practice tasks on convert given orthographic views into an isometric view draw

I am an SS2 student studying Building Tools and Freehand Sketching in Technical Drawing. E

Set me a small project on twelve-position method on the board, stressing that each crank p

Give me a practical task on determine the intersection of a 30 mm square prism entering a

I am an SS2 student studying Perspective Drawing II in Technical Drawing. Explain drawing

Set me a quick recall test on drawing a circle in perspective by enclosing it in a square