Technical Drawing

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Show me a worked example on given two sides and the included angle with an error somewhere

Show me a worked example on success: all three constructions within 0.5 mm and ±1° of the

Show me a worked example on 2. State the properties of each type of quadrilateral with an

Show me a worked example on 4. Calculate the interior and exterior angles of any regular p

Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o

Show me a worked example on calculating the linear ratio from a given area ratio with an e

Let me talk you through 3. Apply the radial (ray) method of enlargement from a chosen pole

Show me a worked example on success: every corresponding side within 1% of the calculated

Show me a worked example on 1. State the principle of tangency and its applications with a

Give me a practice set on plotting the loci of a point at a fixed distance from a line for

Show me a worked example on plotting the path of a point on a crank mechanism with an erro

Show me a worked example on the meaning of the special curves with an error somewhere in i

Show me a worked example on the meaning of development and its applications with an error

Show me a worked example on 4. Produce models of geometrical solids from their development

Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr

Show me a worked example on success: a correctly named and exported file produced that mat

You are my personal SS1 Technical Drawing tutor. Teach me 1. Define technical drawing in y

Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a

Quiz me on 4. Explain the geometric basis of each construction using bisectors, from the S