Technical Drawing

Show me a worked example on drawing an isometric circle of 40 mm diameter by the four-cent

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Show me a worked example on the angle of inclination of the lamina to the horizontal plane

Show me a worked example on the meaning of an opening in a building with an error somewher

Write a short SS2 Technical Drawing answer about the meaning of an arch that contains thre

Write a short SS2 Technical Drawing answer about annotate every material with leader lines

Give me a practice set on comparing the two curves and account for any difference for SS2

Give me a practice set on lay a plastic gear or bicycle sprocket over their finished invol

Set me five practice tasks on the four conic sections and the cutting plane that produces

Take swap sheets and mark each other's work against a three-point checklist out of the tex

Give me a practice set on cutting paper cylinder to show that the seam edge of the develop

Show me a worked example on suggest, with reasons, a suitable board thickness and folding

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Set me five practice tasks on why the curve becomes two straight lines when the two cylind

Give me a practical task on determine the intersection of a 30 mm square prism entering a

Give me a practice set on out the standard layout on the board, moving the station point t

I am an SS2 student studying Perspective Drawing II in Technical Drawing. Explain drawing

Give me a practice set on arranging three cut-out views on the desk in first angle order f

I am revising Orthographic Projection II for SS2 Technical Drawing. Test me on assessed AO

I am an SS2 student studying Auxiliary Views III in Technical Drawing. Explain obtain the