Technical Drawing

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Show me a worked example on success: a correctly named and exported file produced that mat

Set me five practice tasks on two advantages of CADD, at the level expected in SS1 Drawing

Set me a quick recall test on 2. Prepare a title block and border to standard proportions

Set me five practice tasks on demonstrating safe handling of board, T-square and compass,

Write a short SS1 Technical Drawing answer about 4. Divide a straight line into any number

Show me how each line type against the standard line chart. Students produce a reference s

Take drawing a large circle and label all named parts out of the textbook. Describe a real

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

You are my personal SS1 Technical Drawing tutor. Teach me 1. Enlarge a given plane figure

I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce

I am going to explain 3. Explain why triangles on the same base and between the same paral

Write a short SS1 Technical Drawing answer about 1. Construct an arc of given radius inter

I am an SS1 student studying Tangents and Tangency II in Technical Drawing. Explain 2. Con

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Take work through the three arc-tangency cases from given data out of the textbook. Descri

Let me talk you through 2. Construct an ellipse by the four-centre, concentric-circles and

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o