Technical Drawing

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

Set me five practice tasks on preparing a title block to given proportions, at the level e

Show me a worked example on producing vertical and inclined lettering to consistent height

Set me five practice tasks on constructing the special angles without a protractor, at the

Show me a worked example on success: every constructed angle within ±1° when checked with

Set me a quick recall test on 4. Construct eccentric and concentric circles to given dimen

Take drawing a large circle and label all named parts out of the textbook. Describe a real

Set me five practice tasks on success: all ten circle parts correctly labelled and spacing

Show me a worked example on drawing and interpret both projection symbols with an error so

Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o

Act as my study partner. I will teach you 4. Convert a given irregular polygon into a tria

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

Show me a worked example on constructing arcs internally touching, externally enclosing an

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Show me a worked example on consolidation of polygons, scales, enlargement and reduction,

Set me five practice tasks on construction accuracy reported separately to parents, at the

Show me a worked example on success: both drawings fully dimensioned with an error somewhe

Show me a worked example on 4. Construct a simple isometric drawing of a rectangular solid

Show me a worked example on success: four-centre ellipses drawn correctly in all three pla

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o