Technical Drawing

I am an SS2 student studying Orthographic Projection III in Technical Drawing. Explain add

Show me how converting a given first angle drawing into an isometric view works in real li

Give me a practice set on modelling one converted solid in clay or card for SS2 Technical

Give me a practice set on measuring the inclined face on both the ordinary for SS2 Technic

Show me a worked example on drawing the auxiliary views of a full hexagonal prism and a sq

Give me a practice set on comparing their auxiliary outline of the cone for SS2 Technical

Show me a worked example on drawing the second auxiliary elevation of a shaped block and l

Give me a practice set on compile a short class error list from marked work for SS2 Techni

Show me a worked example on drawing the auxiliary elevation of a truncated square pyramid

Give me a practical task on LINE, OFFSET, TRIM and ELLIPSE commands on the projector from

Show me a worked example on producing and plot an isometric drawing of a given block at 1:

Show me a worked example on constructing orthographic views of a truncated solid in AutoCA

Give me a practice set on rotating the UCS and setting up a viewport so the auxiliary dire

Set me a small project on drawing a truncated hexagonal prism, produce its auxiliary eleva

Take comparing the CAD auxiliary with their Week 8 board drawing out of the textbook. Desc

Show me a worked example on produce, dimension and plot an auxiliary elevation of a trunca

I am an SS2 student studying Traces of Points and Lines in Technical Drawing. Explain proj

Show me how are given a plan and elevation only and must state the position of each point

Show me a worked example on drawing the plan and elevation of five points at stated distan

Set me five practice tasks on what is meant by the first quadrant and why technical drawin