Technical Drawing
AI prompts for senior secondary learners.
📅 36-Week WAEC Study Guide for Technical Drawing →197 prompts matching "Drawing a truss to scale"
Spot my mistake: 4. Interpret a three-view orthographic drawing and sketch the solid it represents
Write a short SS1 Technical Drawing answer about 4. Interpret a three-view orthographic dr
Subscribe to unlock allLet me explain: 3. Use construction layers to build up complex isometric shapes
I am going to explain 3. Use construction layers to build up complex isometric shapes to y
Subscribe to unlock allSpot my mistake: 4. Produce a finished isometric drawing of a composite object from orthographic views
Give me a wrong or muddled explanation of 4. Produce a finished isometric drawing of a com
Subscribe to unlock allPractice set: Producing a composite isometric drawing from orthographic views
Set me five practice tasks on producing a composite isometric drawing from orthographic vi
Subscribe to unlock allTeach me: 2. Demonstrate the types of oblique drawing: cavalier and cabinet
Be my SS1 Technical Drawing teacher for this one point: 2. Demonstrate the types of obliqu
Subscribe to unlock allQuiz: 3. Construct an oblique drawing using the box method
Quiz me on 3. Construct an oblique drawing using the box method, from the SS1 Technical Dr
Subscribe to unlock allTeach me: 2. Use a graphics package for lettering and for drawing lines and angles
You are my personal SS1 Technical Drawing tutor. Teach me 2. Use a graphics package for le
Subscribe to unlock allQuiz: 3. Use a graphics package to produce plane and pictorial figures
I am revising Introduction to Computer Graphics and Cad for SS1 Technical Drawing. Test me
Subscribe to unlock allQuiz: 2. Distinguish between drawing materials and drawing instruments
I am revising Drawing Materials and Equipment for SS1 Technical Drawing. Test me on 2. Dis
Subscribe to unlock allPractice set: And names each item in a full drawing set
Give me a practice set on and names each item in a full drawing set for SS1 Technical Draw
Subscribe to unlock allWAEC prep: The two classifications of drawing, compared
Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o
Subscribe to unlock allPractice set: Preparing a title block to given proportions
Set me five practice tasks on preparing a title block to given proportions, at the level e
Subscribe to unlock allSpot my mistake: Producing vertical and inclined lettering to consistent height
Show me a worked example on producing vertical and inclined lettering to consistent height
Subscribe to unlock allPractice set: Constructing the special angles without a protractor
Set me five practice tasks on constructing the special angles without a protractor, at the
Subscribe to unlock allSpot my mistake: Success: every constructed angle within ±1° when checked with a protractor
Show me a worked example on success: every constructed angle within ±1° when checked with
Subscribe to unlock allQuiz: 4. Construct eccentric and concentric circles to given dimensions
Set me a quick recall test on 4. Construct eccentric and concentric circles to given dimen
Subscribe to unlock allReal-life Nigeria: Drawing a large circle and label all named parts
Take drawing a large circle and label all named parts out of the textbook. Describe a real
Subscribe to unlock allPractice set: Success: all ten circle parts correctly labelled and spacings accurate to 0.5 mm
Set me five practice tasks on success: all ten circle parts correctly labelled and spacing
Subscribe to unlock allSpot my mistake: Drawing and interpret both projection symbols
Show me a worked example on drawing and interpret both projection symbols with an error so
Subscribe to unlock allSpot my mistake: 4. Determine the linear ratio corresponding to a given ratio of areas
Show me a worked example on 4. Determine the linear ratio corresponding to a given ratio o
Subscribe to unlock all