Technical Drawing

Take lesson with the load path from roof to soil, drawing it as arrows on a board section

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Be my SS2 Technical Drawing teacher for this one point: drawing the tangent and normal at

I am going to explain graphic Products candidates meet the same content when drawing movin

Give me a wrong or muddled explanation of drawing a four-bar linkage to given link lengths

Quiz me on drawing a slider-crank mechanism and plot the locus of the mid-point of the con

Set me a small project on drawing two cylinders of 50 mm and 30 mm diameter meeting at 90

Show me a worked example on three uses of perspective drawing and distinguish it from isom

I am revising Perspective Drawing I for SS2 Technical Drawing. Test me on drawing a rectan

Set me a quick recall test on drawing a circle in perspective by enclosing it in a square

Show me a worked example on four line types used in orthographic drawing and the purpose o

Show me a worked example on dimension a drawing using the aligned and the unidirectional s

Take drawing and fully dimension a bracket in third angle projection out of the textbook.

Act as my study partner. I will teach you drawing the auxiliary views of a full cone and a

Show me a worked example on drawing the auxiliary views of a full hexagonal prism and a sq

Let me talk you through drawing the auxiliary elevation and auxiliary plan of a truncated

Write a short SS2 Technical Drawing answer about drawing the auxiliary elevation and auxil

Show me a worked example on producing and plot an isometric drawing of a given block at 1:

Set me five practice tasks on why layers, rather than a single drawing layer, are used for

Show me a worked example on drawing the plan and elevation of five points at stated distan