Technical Drawing

AI prompts for senior secondary learners.

📅 36-Week WAEC Study Guide for Technical Drawing →

Three prompts in each subject are free to try. One subscription opens every subject and every prompt in senior secondary, or subscribe your whole school. Already have a code? Enter it here.

Show:All prompts Free

Year group:All years SS 1 SS 2 SS 3

Year 12 key words:angles and triangles bisecting and dividing building drawing circles and tangents conic sections drawing instruments forces and structures isometric drawing lines and lettering orthographic projection polygons scales

+ 2 more key words

screw threads and fasteners sectional views

270 prompts matching "Swap sheets and mark each other's work against a three-point checklist"

Spot my mistake: Reading a weld symbol below the reference line as though it sat above it

PPJ-TDR-00531 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below

Subscribe to unlock all

Spot my mistake: Assuming a transition fit always leaves clearance

PPJ-TDR-00532 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a transition fit a

Subscribe to unlock all

Spot my mistake: Drawing the true helix of a screw thread rather than its conventional representation

PPJ-TDR-00533 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on drawing the true helix of a

Subscribe to unlock all

Spot my mistake: Sectioning a shaft, a bolt or a rib along its length

PPJ-TDR-00535 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on sectioning a shaft, a bolt

Subscribe to unlock all

Spot my mistake: Showing the steps of an offset cutting plane as lines in the sectional view

PPJ-TDR-00536 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on showing the steps of an off

Subscribe to unlock all

Spot my mistake: Leaving hidden detail out of a first angle view because it cannot be seen

PPJ-TDR-00540 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on leaving hidden detail out o

Subscribe to unlock all

Spot my mistake: Assuming a line inclined in both views can have its true length measured in either

PPJ-TDR-00541 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in

Subscribe to unlock all

Spot my mistake: Measuring the angle between two planes in a view where neither appears as an edge

PPJ-TDR-00542 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between

Subscribe to unlock all

Spot my mistake: Developing a transition piece as one flat shape without triangulation

PPJ-TDR-00543 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on developing a transition pie

Subscribe to unlock all

Spot my mistake: Assuming the centre of gravity of a lamina must lie within its outline

PPJ-TDR-00544 Similar prompts

Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the centre of grav

Subscribe to unlock all