Technical Drawing

I am going to explain graphic Products candidates meet the same content when drawing movin

Set me a small project on twelve-position method on the board, stressing that each crank p

Show me a worked example on what happens to the output at a dead-centre position with an e

Set me five practice tasks on the four conic sections and the cutting plane that produces

Show me a worked example on why the cut face appears as a straight line in one view and an

Give me a practice set on one truncated hexagonal prism on the board for SS2 Technical Dra

I am revising Development and Card Models for SS2 Technical Drawing. Test me on assessed A

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Act as my study partner. I will teach you assemble one intersecting pair in card and check

I am going to explain rendering the finished view with tone and texture to distinguish two

Give me a practice set on arranging three cut-out views on the desk in first angle order f

Show me a worked example on dimension a drawing using the aligned and the unidirectional s

I am revising Orthographic Projection II for SS2 Technical Drawing. Test me on assessed AO

Set me a small project on up a poorly dimensioned drawing on the board, the kind I could f

Show me a worked example on four rules of dimensioning with an error somewhere in it. Do n

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Write a short SS2 Technical Drawing answer about constructing an isometric view from given

Give me a practical task on enclosing box on the board and removes material step by step s

Give me a practice set on measuring the inclined face on both the ordinary for SS2 Technic

Give me a practical task on one second auxiliary elevation on the board from Auxiliary Vie