Technical Drawing

I am revising Polygons II for SS1 Technical Drawing. Test me on 2. Construct a regular pol

Show me a worked example on calculating the linear ratio from a given area ratio with an e

Write a short SS1 Technical Drawing answer about 3. Construct a cycloid and a trochoid fro

Act as my study partner. I will teach you 3. Develop the pattern for a transition piece be

Show me a worked example on producing three correct views of a given solid with an error s

Act as my study partner. I will teach you 3. Differentiate between isometric and non-isome

Show me a worked example on 4. Construct a simple isometric drawing of a rectangular solid

Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr

Set me five practice tasks on constructing isometric squares, rectangles, arcs and circles

Quiz me on 3. Construct an oblique drawing using the box method, from the SS1 Technical Dr

Act as my study partner. I will teach you 4. Construct an oblique drawing using the centre

Show me a worked example on producing vertical and inclined lettering to consistent height

Show me a worked example on 4. Apply studio rules consistently and maintain instruments in

Show me a worked example on and produce all six line types at correct weight with an error

Show me a worked example on constructing an inscribed, a circumscribed and an escribed cir

Show me a worked example on constructing special quadrilaterals and one from four sides an

Show me a worked example on drawing and interpret both projection symbols with an error so

Show me a worked example on calculating interior and exterior angles for three named polyg

Show me a worked example on constructing arcs internally touching, externally enclosing an

Show me a worked example on 1. Explain what CAD is and compare CAD with manual drawing for