Technical Drawing

Act as my study partner. I will teach you 4. Convert a given irregular polygon into a tria

Give me a practice set on completing the four standard equal-area constructions on one she

Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

I am revising Special Curves for SS1 Technical Drawing. Test me on 1. Define and distingui

Set me five practice tasks on success: both folded models close with a gap of less than 2

I am revising Orthographic Projection for SS1 Technical Drawing. Test me on 2. Draw and in

Give me a wrong or muddled explanation of 4. Distinguish chain, parallel and running dimen

You are my personal SS1 Technical Drawing tutor. Teach me 1. Construct isometric squares a

Give me a practice set on four-centre ellipse inside an isometric rhombus. Students constr

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

You are my personal SS1 Technical Drawing tutor. Teach me 2. Use a graphics package for le

Set me five practice tasks on constructing the special angles without a protractor, at the

Show me a worked example on given two sides and the included angle with an error somewhere

Show me a worked example on drawing and interpret both projection symbols with an error so

Show me a worked example on achieve at least 60% on a full mock paper with an error somewh

Show me a worked example on calculating the linear ratio from a given area ratio with an e

Show me a worked example on success: calculated areas of original and converted figures ag

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,

Show me a worked example on consolidation of polygons, scales, enlargement and reduction,