Technical Drawing

I am going to explain 3. Construct the special angles 30°, 45°, 60°, 75°, 90°, 105° and 12

Set me five practice tasks on constructing the special angles without a protractor, at the

Show me a worked example on success: every constructed angle within ±1° when checked with

Show me a worked example on given two sides and the included angle with an error somewhere

Set me a small project on constructing a specified triangle accurately within a time limit

Write a short SS1 Technical Drawing answer about 2. Draw a circle and label its parts corr

I am an SS1 student studying Circles and Triangles I in Technical Drawing. Explain 3. Dist

Show me a worked example on constructing an inscribed, a circumscribed and an escribed cir

Set me five practice tasks on the types of quadrilaterals with their properties, at the le

Show me a worked example on constructing special quadrilaterals and one from four sides an

I am an SS1 student studying Drawing Standards and Conventions in Technical Drawing. Expla

Set me five practice tasks on success: both projection symbols drawn to correct proportion

I am going to explain consolidation of drawing practice, line work to you, as an SS1 Techn

Show me a worked example on 4. Calculate the interior and exterior angles of any regular p

Show me a worked example on calculating interior and exterior angles for three named polyg

Set me five practice tasks on success: five dimensions set off from the diagonal scale cor

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

Write a short SS1 Technical Drawing answer about 4. Verify the accuracy of an enlargement

Show me a worked example on success: every corresponding side within 1% of the calculated

I am going to explain 3. Explain why triangles on the same base and between the same paral