Technical Drawing

Write a short SS1 Technical Drawing answer about 4. Use drawing materials and instruments

Set me five practice tasks on demonstrating safe handling of board, T-square and compass,

Show me how each line type against the standard line chart. Students produce a reference s

Give me a wrong or muddled explanation of 4. Construct any acute angle using the tangent a

You are my personal SS1 Technical Drawing tutor. Teach me given one side and two angles, a

Set me five practice tasks on constructing triangles from all three sets of given data, at

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

I am going to explain consolidation of drawing practice, line work to you, as an SS1 Techn

Set me five practice tasks on accuracy of construction assessed separately from knowledge,

Let me talk you through 3. Construct a regular polygon using the diagonal method from the

Give me a wrong or muddled explanation of 4. Construct a diagonal scale and use it to read

Quiz me on 2. Distinguish between enlargement by ratio of sides and by ratio of areas, fro

Act as my WAEC Technical Drawing examiner. I am in SS1. Set me an exam-standard question o

You are my personal SS1 Technical Drawing tutor. Teach me 1. Enlarge a given plane figure

I am revising Enlargement and Reduction II for SS1 Technical Drawing. Test me on 2. Reduce

Set me five practice tasks on success: radius and tangent perpendicular within ±1° at ever

Set me a quick recall test on 3. Construct an arc touching one circle internally and enclo

I am going to explain 4. Blend arcs and lines smoothly, marking all points of tangency to

Take work through the three arc-tangency cases from given data out of the textbook. Descri

Act as my study partner. I will teach you 4. Relate loci to the motion produced by levers,