Technical Drawing
AI prompts for senior secondary learners.
📅 36-Week WAEC Study Guide for Technical Drawing →296 prompts matching "Drawing the plan and elevation of five points at stated distances above the HP"
Let me explain: Pad and raft foundations
I have just studied pad and raft foundations in my SS3 Technical Drawing class. Let me exp
Subscribe to unlock allLet me explain: Reinforced concrete columns and beams
I have just studied reinforced concrete columns and beams in my SS3 Technical Drawing clas
Subscribe to unlock allLet me explain: Plumbing symbols and pipe runs
I have just studied plumbing symbols and pipe runs in my SS3 Technical Drawing class. Let
Subscribe to unlock allLet me explain: Representing timber, insulation and hardcore
I have just studied representing timber, insulation and hardcore in my SS3 Technical Drawi
Subscribe to unlock allSpot my mistake: A section hatched with the wrong material convention
Act as my SS3 Technical Drawing tutor. Write a short answer on a section hatched with the
Subscribe to unlock allLet me explain: Reading weld size and length from a symbol
I have just studied reading weld size and length from a symbol in my SS3 Technical Drawing
Subscribe to unlock allLet me explain: Clearance, interference and transition fits
I have just studied clearance, interference and transition fits in my SS3 Technical Drawin
Subscribe to unlock allLet me explain: Bolts, studs and set screws
I have just studied bolts, studs and set screws in my SS3 Technical Drawing class. Let me
Subscribe to unlock allLet me explain: Spring washers and tab washers
I have just studied spring washers and tab washers in my SS3 Technical Drawing class. Let
Subscribe to unlock allLet me explain: Removed and revolved sections
I have just studied removed and revolved sections in my SS3 Technical Drawing class. Let m
Subscribe to unlock allLet me explain: Oblique circles and curves
I have just studied oblique circles and curves in my SS3 Technical Drawing class. Let me e
Subscribe to unlock allLet me explain: Setting up a two-point perspective
I have just studied setting up a two-point perspective in my SS3 Technical Drawing class.
Subscribe to unlock allSpot my mistake: Assuming a single set square will give every angle a drawing requires
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a single set squar
Subscribe to unlock allSpot my mistake: Treating an ellipse as a shape struck from four centres rather than plotted as a locus
Act as my SS3 Technical Drawing tutor. Write a short answer on treating an ellipse as a sh
Subscribe to unlock allSpot my mistake: Assuming every floor in a building is a solid floor cast on the ground
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming every floor in a b
Subscribe to unlock allSpot my mistake: Dimensioning every part fully on an assembly drawing
Act as my SS3 Technical Drawing tutor. Write a short answer on dimensioning every part ful
Subscribe to unlock allSpot my mistake: Assuming a raft foundation is chosen where the ground is strongest
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a raft foundation
Subscribe to unlock allSpot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Subscribe to unlock allSpot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Subscribe to unlock allLet me explain: The second auxiliary projection
I have just studied the second auxiliary projection in my SS3 Technical Drawing class. Let
Subscribe to unlock all