Technical Drawing

Show me a worked example on what happens to the output at a dead-centre position with an e

Give me a practice set on one truncated hexagonal prism on the board for SS2 Technical Dra

Show me a worked example on cut, fold and assemble the developments in cardboard with an e

I am revising Development and Card Models for SS2 Technical Drawing. Test me on assessed A

Set me five practice tasks on your model against the drawing, at the level expected in SS2

Give me a practice set on paper tube into a slot cut in a larger tube to show the saddle c

Act as my study partner. I will teach you assemble one intersecting pair in card and check

Act as my WAEC Technical Drawing examiner. I am in SS2. Set me an exam-standard question o

Show me a worked example on three uses of perspective drawing and distinguish it from isom

I am revising Perspective Drawing I for SS2 Technical Drawing. Test me on drawing a rectan

Give me a practice set on out the standard layout on the board, moving the station point t

Set me a small project on photograph or sketch a corridor in the school, the kind I could

Write a short SS2 Technical Drawing answer about set out two vanishing points on the horiz

I am going to explain rendering the finished view with tone and texture to distinguish two

Give me a practice set on assessing each other's rendering against three criteria for SS2

Give me a practical task on card box round a small block to show the three planes opening

Give me a practice set on arranging three cut-out views on the desk in first angle order f

Show me a worked example on dimension a drawing using the aligned and the unidirectional s

I am revising Orthographic Projection II for SS2 Technical Drawing. Test me on assessed AO

Set me a small project on up a poorly dimensioned drawing on the board, the kind I could f