Technical Drawing
AI prompts for senior secondary learners.
📅 36-Week WAEC Study Guide for Technical Drawing →296 prompts matching "4. Distinguish chain, parallel and running dimensioning and select the appropria"
Spot my mistake: Reading a weld symbol below the reference line as though it sat above it
Act as my SS3 Technical Drawing tutor. Write a short answer on reading a weld symbol below
Subscribe to unlock allSpot my mistake: Drawing the true helix of a screw thread rather than its conventional representation
Act as my SS3 Technical Drawing tutor. Write a short answer on drawing the true helix of a
Subscribe to unlock allSpot my mistake: Showing the steps of an offset cutting plane as lines in the sectional view
Act as my SS3 Technical Drawing tutor. Write a short answer on showing the steps of an off
Subscribe to unlock allSpot my mistake: Assuming the horizon line sits at the top of the sheet whatever the viewpoint
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the horizon line s
Subscribe to unlock allSpot my mistake: Assuming a line inclined in both views can have its true length measured in either
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming a line inclined in
Subscribe to unlock allSpot my mistake: Measuring the angle between two planes in a view where neither appears as an edge
Act as my SS3 Technical Drawing tutor. Write a short answer on measuring the angle between
Subscribe to unlock allSpot my mistake: Assuming the centre of gravity of a lamina must lie within its outline
Act as my SS3 Technical Drawing tutor. Write a short answer on assuming the centre of grav
Subscribe to unlock allLet me explain: The angle of inclination of a line to a plane
I have just studied the angle of inclination of a line to a plane in my SS3 Technical Draw
Subscribe to unlock allLet me explain: The arrangement of views in third angle
I have just studied the arrangement of views in third angle in my SS3 Technical Drawing cl
Subscribe to unlock allLet me explain: The second auxiliary projection
I have just studied the second auxiliary projection in my SS3 Technical Drawing class. Let
Subscribe to unlock allLet me explain: Developing the surface of a cylinder
I have just studied developing the surface of a cylinder in my SS3 Technical Drawing class
Subscribe to unlock allLet me explain: The triangle of forces
I have just studied the triangle of forces in my SS3 Technical Drawing class. Let me expla
Subscribe to unlock allLet me explain: The drawings that make up a set of working drawings
I have just studied the drawings that make up a set of working drawings in my SS3 Technica
Subscribe to unlock allLet me explain: The parts of a panelled door
I have just studied the parts of a panelled door in my SS3 Technical Drawing class. Let me
Subscribe to unlock allLet me explain: The members of a king post truss
I have just studied the members of a king post truss in my SS3 Technical Drawing class. Le
Subscribe to unlock allLet me explain: The part or local section
I have just studied the part or local section in my SS3 Technical Drawing class. Let me ex
Subscribe to unlock allLet me explain: Drawing an isometric circle by the four-centre method
I have just studied drawing an isometric circle by the four-centre method in my SS3 Technical Drawing class. Let me explain it back to you in my own words, then tell me plainly what I got wrong or left out. Ask me one follow-up question afterwards to test whether I really understood it.
launch and paste in:
Let me explain: The line of intersection of two planes
I have just studied the line of intersection of two planes in my SS3 Technical Drawing cla
Subscribe to unlock allLet me explain: Developing the surface of a frustum
I have just studied developing the surface of a frustum in my SS3 Technical Drawing class.
Subscribe to unlock allLet me explain: Finding the centroid of a composite figure
I have just studied finding the centroid of a composite figure in my SS3 Technical Drawing
Subscribe to unlock all